Cart is empty
- 2 in. taller than current +2 in. Sweeper bars
- The throttle grip end is notched and the bar is milled for internal wiring to accommodate the electronic throttle control sensor unit (can also be used on pre-2008 models)
- Cable changes may be required; wire extension for the ETC may or may not be needed
- Dimpled, knurled and available in gloss black finish
- Made in the U.S.A.
1" Diameter Clamping Width: 11 1/2 in.
Inside Width of Knurling/Outside: 2in/4 1/4 in.
Drilled for Internal Wiring: Yes
Dimpled to Prevent Pinching Control Wires: Yes
Notches for 08-up H-D with Electronic Throttle: Yes
No posts found