Flush Brake Light and Turn Signals

• 7″x4″ center brake light
• 4″ tall side flange lights
• Available in multiple fenders & designs

This setup uses 7″ wide by 4″ tall brake light with 80 LEDs. The turn signals are then flush mounted into the side flanges of the rear fender. This setup is available in both our Bagger Fenders and Summit Fenders for all models.

Your new flush mounted parts will arrive with everything pre-drilled and pre-fit, all lights flush mounted, all bodywork complete, and the parts will be in a final primer and ready to go to paint. We can pre-wire the taillights into one of our plug-n-play wiring harnesses which will serve as a direct plug-in for your stock wiring harness. Our custom harness also features a load equalizer for the LEDs and quick disconnect clips for the saddlebag lights.

These custom parts are proudly made in the USA and hand built in Indiana.