- 2 in. taller than current +2 in. Sweeper bars
- The throttle grip end is notched and the bar is milled for internal wiring to accommodate the electronic throttle control sensor unit (can also be used on pre-2008 models)
- Cable changes may be required; wire extension for the ETC may or may not be needed
- Dimpled, knurled and available in duplex nickel chrome plated
- Made in the U.S.A.Dimensions:
Width: 33″
Rise: 12 1/2″
Pullback: 9″
Center Width: 8″
End Rise: 13″
1″ Diameter Clamping Width: 8″
Inside Width of Knurling/Outside: 2″/4 1/8″
Drilled for Internal Wiring: Yes
Dimpled to Prevent Pinching Control Wires: Yes
Three Notches for 08-up H-D with Electronic Throttles: Yes
Reviews
There are no reviews yet